Materials that are difficult to cut require the use of a water jetting nozzle with an abrasive entrainment chamber.
A high pressure water nozzle inside the assembly creates a water jet. This pressurised water jet travels through the entrainment chamber at high speed to a focussing nozzle dragging the air in the chamber with it and creating a vacuum. Abrasive material is fed into the side of the chamber under air pressure. The abrasive particles are sucked into the air around the water jet and accelerated into the water stream to emit from the focussing nozzle.
Type B 1500
Operating pressure: 1500 bar High pressure connection: Pressure ring / Pressure nut M 26 x 1,5 for M 14 x 1,5 LH (Nipple) Flow rate: 25 – 40 l/min Designed to be mounted on a nozzle carrier.
Application examples:
Concrete cutting
Steelwork cutting
Type B 4000
Operating pressure: 4000 bar High pressure connection: Pressure ring / Pressure nut M 26 x 1,5 for M 14 x 1,5 LH (Nipple) Flow rate: 10 - 25 l/min Designed to be mounted on a nozzle carrier.
Application examples:
Concrete cutting
Steelwork cutting
Type S 4000 with collimation tube
Operating pressure: 4000 bar High pressure connection: M 14 x 1,5 LH (Standard) with adapter to M 26 x 1,5 Flow rate: max. 10 l/min Application: especially for use with a cutting table, i.e. cutting shapes in metals, glass, plastics, ceramics etc.
The entrainment chamber can be removed without the need for tools for pure water jet cutting of softer materials
